Removal Of Seat Elevator/Seat Column - Permobil Street Service Manual

Seat elevator
Seat elevator

Removal of seat elevator/Seat column/

Fixed seat post
1. Remove the chassis covers; see page 7.
2. Remove the batteries; see page 8.
3. Remove the seat elevator's upper bracket. It is
attached with two screws; see figure.
4. When removing the seat lift, undo the bracket
which holds the General Module in position.
The bracket is attached with two screws on the
chassis, see illustration.
5. Lift the General Module and bracket out of the
chassis. Detach the cables to the seat lift
motor and soft pot from the General Module by
pulling the two connectors straight out, see
illustration below.
6. Undo the seat lift's four lower fixing screws on
the underside of the chassis, see illustration.
7. By angling the seat lift as you lift it, it can be
removed without having to undo the bracket
for the ICS Master Module.
Fitting
Fitting is the reverse procedure.
General Module and its cables.
.
1
2
3
Cables for:
1. ICS Master Module
2. Seat lift motor
3. Soft pot.
30
Seat elevator's upper attachment screws.
The bracket on the General Module is attached
with two screws.
Seat lift's lower fixing screws.