6.14) Cleaning
6.14.1) Cleaning Cycle and Method
Caution
No.
1
Around hook
2
Thread take-up lever / Thread tension adjusting device
Around the moving and fixed blades.
3
Use air to clean the moving and fixed blades under the
needle plate.
6.15) Handling of Waste Oil
When the waste oil can attached to the rear side of the table
is filled to the full, separate and empty the can.
Caution
36
1) Make sure to turn "off" the machine power before conducting cleaning.
2) Assemble the parts which are disassembled for cleaning.
Cleaning Area
1) When separating the waste oil can, take caution not to drop it to the floor.
2) Just in case for dropping the waste oil can to the floor, place cloth, paper or oil dish on the
floorwhen separating the waste oil can.
Cleaning Frequency
Everyday
Once a week
Three times a week
Waste Oil Can