2) Y Origin Setting; Oil Supply; 1) Regular Check List - SunStar SPS/E-BS1201 Series User Manual

6.12.2) Y Origin Setting

1) Disassemble the bed cover(right).
2) Set the distance between the Y-feed arm and the bed side at 24mm.
3) Move the upper feed plate to the center in the Y-axis direction and make sure to maintain the distance at 24mm.
4) Loosen the tightening screw for the Y-sensor plate. Move the end of the Y-sensor plate to the center of the sensor and
fasten the tightening screw with a spanner.

6.13) Oil Supply

1) During machine check or maintenance, please observe the safety rules on machine and
electricity.
2) Make sure that the power is off before maintenance work begins.
Caution

6.13.1) Regular Check List

1) For the parts which need regular check, conduct cleaning and lubrication and add grease to maintain high machine
performance.
2) Test the tension of each driving belt.
3) Without regular machine check, the following problems might result:
Abnormal abrasion of the moving parts in a wet condition due to the insufficient lubrication and grease injection
Abnormal operation due to dust or foreign materials gathered at the moving parts
1) If machine damage or mal-operation occurs due to the failure to clean and lubricate the machine
through regular checking, SunStar will not be held liable.
2) Adjust the cleaning cycle depending on the use conditions and environment.
Caution
Tightening
Screw
Y-Sensor Plate
Y-Sensor
Y-Sensor Bracket
33