Radyne DMD2401 LB Installation And Operation Manual page 96

DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
<2> Transmit ESC
Audio #1 Volume
<2> Transmit ESC
Audio #2 Volume
Opcode: <2602h>
<4> Frequency
Opcode: <2604h>
<4> Data Rate
Opcode: <2606h>
<1> Modulation Type
Opcode: <2607h>
TM075 - Rev. 1.3
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
If G.703 daughter card is installed:
0 = G.703 Unbalanced E1
1 = G.703 Balanced E1
2 = G.703 T1, B8ZS
If Synchronous multiprotocol daughter card is installed:
0 = V.35
1 = RS-422
2 = RS-232
Note: The following two bytes apply only if an IDR OR
IBS interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
-20 to +10, signed binary value in dB
Note: The following two bytes apply only if an IDR OR
IBS interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
-20 to +10, signed binary value in dB
Command a Modulator's Frequency
Note: The following command will also turn the carrier
off to protect the satellite.
Unsigned Binary Value in Hz
Command a Modulator's Data Rate
Note: The following command will also turn the carrier
off to protect the satellite.
Unsigned Binary Value in BPS
Command a Modulator's Modulation Type
Note: The following command will also turn the carrier
off to protect the satellite.
0 = QPSK, 1 = BPSK, 2 = 8PSK, 4 = OQPSK
Command a Modulator's Convolutional Encoder
User Interfaces
4-59