Radyne DMD2401 LB Installation And Operation Manual page 115

User Interfaces
<2> Raw BER
Mantissa
<2> Corrected BER
Mantissa
<2> EbNo
<1> Raw BER
Exponent
<1> Corrected BER
Exponent
<1> BER/EbNo Status
<1> Input Level
<1> Input Level
State
<1> AGC Voltage
Opcode: <2437h>
<1> Lock Status
Opcode: <2A00h>
<4> Frequency
<4> Data Rate
<1> Sweep Boundary
<4> External
Reference
<1> Freq. Reference
Source
<1> Input Level Limit
<1> Demodulation
Type
<1> Convolutional
4-78
DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
Bytes 1 - 2 = Unsigned Binary Value Raw BER
Bytes 1 - 2 = Unsigned Binary Value Corrected BER
Unsigned Binary Value, 2 Decimal Places Implied
Byte 3 = Unsigned Binary Value Exponent
Byte 3 = Unsigned Binary Value Exponent
Bit 0 = Raw BER and Corrected BER Status (1 = Valid)
Bit 1 = Test 2047 BER Status (1 = Valid)
Bits 2 - 3 = EbNo Status (0 = EbNo is Invalid, 1 = EbNo is
Valid, 2 = EbNo is Smaller Than Indicated Value, 3 =
EbNo is Greater Than Indicated Value)
Bits 4 - 7 = Reserved
Binary Value in -1 dB Steps, Negative Sign Implied
Signed Binary (0 = Equal to, 1 = Greater Than, -1 = Less
Than Value in -1 dB Steps, Negative Sign Implied
In Hex, decimal point implied.
Query a Demodulator's Lock Status
Bit 0 = Demod Chipset Lock (0 = Unlocked, 1 = Locked)
Bit 1 = Viterbi Lock (0 = Unlocked, 1 = Locked)
Bit 2 = Reed-Solomon Lock (0 = Unlocked, 1 = Locked)
Bit 3 = Sequential Lock (0 = Unlocked, 1 = Locked)
Bits 4 – 7 = Spares
(Decoders not in use default to locked state)
Command a Demodulator's Configuration
Binary Value, 1Hz Steps
Binary Value, 1 BPS Steps
Sweep Limits, Max of ± 255 kHz
Unsigned Binary Value in Hz
0 = Internal, 1 = External
Lower Level Limit, Binary Value, 1 dB Steps, Negative Sign
Implied
0 = QPSK, 1 = BPSK, 2 = 8PSK, 4 = OQPSK
0 = None
TM075 – Rev. 1.3