Radyne DMD2401 LB Installation And Operation Manual page 84

DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
<1> Latched Alarm 2
Minor Alarm
<1> Latched Common
Alarm
<1> Online Flag
<1> +5V Voltage
<1> +12V Voltage
<1> -12V Voltage
<2> Temperature
<4> Reserved
<1> Remote AUPC
Status
<2> Remote AUPC
Eb/No
TM075 - Rev. 1.3
Bit 0 = Terrestrial Clock Activity Detect Fault Minor Alarm
Bit 1 = Internal Clock Activity Detect Fault
Bit 2 = Tx Sat Clock Activity Detect Fault
Bit 3 = Tx Data Activity Detect Fault
Bit 4 = Terrestrial AIS (Tx Data AIS Detect Fault)
Bit 5 = Transmit Ext BNC Clock Activity Detect Fault
Bit 6 = Transmit Reed-Solomon Fault
Bit 7 = Tx BUC Fault, LBST Only
(0 = Pass, 1 = Fail)
Bit 0 = -12 V alarm
Bit 1 = +12 V alarm
Bit 2 = +5 V alarm
Bit 3 = Temperature Fault
Bit 4 = Interface FPGA Fault
Bit 5 = Battery Fault
Bit 6 = RAM / ROM Fault
Bit 7 = Spare
(0 = Pass, 1 = Fail)
0 = Offline, 1 = Online
+5 V, Implied Decimal Point (ex: 49 = +4.9 V)
+12 V, Implied Decimal Point (ex: 121 = +12.1 V)
-12 V, Implied Decimal Point and Minus Sign
(ex: 118 = -11.8 V)
Degrees C, Implied Decimal Point (ex: 490 = 49.0 C)
(Temperature is measured at the output amplifier, and does
not represent the overall internal temperature)
Ignore These Bytes
Note: The following three bytes apply only if an
asynchronous interface card, IDR or IBS interface card is
installed, and the AUPC option is installed and the AUPC
is enabled. If not, ignore this byte.
Bit 0 = AUPC Communication Error
Bits 1-2 = Eb/No Status
0 = Eb/No is Invalid
1 = Eb/No is Valid
2 = Eb/No is Smaller Than Indicated Value
3 = Eb/No is Larger Than Indicated Value
Unsigned Binary Value Decimal Point Implied
User Interfaces
4-47