1. Manuals
  2. Brands
  3. Radyne Manuals
  4. Modem
  5. DMD2401 LB
  6. Installation and operation manual

Radyne DMD2401 LB Installation And Operation Manual page 95

L-band satellite modem and odu driver
Hide thumbs
Table of Contents

Advertisement

User Interfaces
<1>
IDR Force
Backward Alarm
1
<1>
IDR Force
Backward Alarm
2
<1>
IDR Force
Backward Alarm
3
<1>
IDR Force
Backward Alarm
4
<1>
Interface Type
4-58
DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
TM075 – Rev. 1.3

Advertisement

Table of Contents
loading

Related Manuals for Radyne DMD2401 LB

Related Products for Radyne DMD2401 LB

This manual is also suitable for:

Dmd2401 st

Table of Contents