Table of Contents
Advertisement
DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
<2>
AUPC Default
Power Level
<1>
Daughter Card
Fault Mask
<1>
Transmit Mode
<1>
Transmit IDR
Overhead Mode
<1>
IDR Backward
Alarm Mask
TM075 - Rev. 1.3
Note: AUPC minimum power level < AUPC default power
level < AUPC max. power level.
Signed value, –50 to –300 (–5.0 to –30 dBm), Implied
Decimal Point
Note: The following two bytes apply only if an
Asynchronous Interface Card, or an IDR OR IBS Interface
Card is installed, AND the AUPC option is also installed.
If not, set to zero.
Note: AUPC minimum power level < AUPC default power
level < AUPC max. power level.
Signed value, –50 dBm to –300 (–5.0 to –30 dBm), Implied
Decimal Point
Note: The following byte applies only if an IDR OR IBS
interface card is installed. If not, set to zero.
0 = Mask, 1 = Allow
Note: The following byte applies only if an IDR OR IBS
interface card is installed. If not, set to zero.
0 = Closed Net Mode
1 = IDR Mode
2 = IBS Mode
3 = Drop & Insert Mode
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Voice
1 = 64 Kbit Data
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
Bit 0 = IDR Backward Alarm 1
Bit 1 = IDR Backward Alarm 2
Bit 2 = IDR Backward Alarm 3
Bit 3 = IDR Backward Alarm 4
Bit 4 – 7 = Spare
(0 = Mask, 1 = Allow)
User Interfaces
4-57
Advertisement
Table of Contents
