Radyne DMD2401 LB Installation And Operation Manual page 111

User Interfaces
<1> Raw BER
Exponent
<1> Corrected BER
Exponent
<1> Test 2047 BER
Exponent
<1> Offset Frequency
Sign
<1> BER/EbNo Status
<1> Buffer Percent
Full
<1> Input Level
<1> Input Level State
<1> Alarm 5
<1> Backward Alarms
<1> Latched Alarm 5
<1> Control Mode
<1> Alarm 5
4-74
DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
Byte 3 = Unsigned Binary Value Exponent
Byte 3 = Unsigned Binary Value Exponent
Byte 3 = Unsigned Binary Value Exponent
0 = Offset Frequency Pos, 1 = Offset Frequency Neg
Bit 0 = Raw BER and Corrected BER Status (1 = Valid)
Bit 1 = Test 2047 BER Status (1 = Valid)
Bits 2 - 3 = EbNo Status (0 = EbNo is Invalid, 1 = EbNo is
Valid, 2 = EbNo is Smaller Than Indicated Value, 3 =
EbNo is Greater Than Indicated Value)
Bits 4 - 7 = Reserved
Unsigned Binary Value Representing % Buffer Full (0 - 100 in
1% steps)
Unsigned Binary Value in -1 dB Steps, Negative Sign Implied
Signed Binary (0 = Equal to, 1 = Greater Than, -1 = Less
Than Value in -1 dB Steps, Negative Sign Implied)
Bit 0 = IBS/IDR Satellite Multiframe Sync Loss
Bit 1 = IBS/IDR Satellite Frame Sync Loss
Bit 2 = Spare
Bit 3 = IBS BER Alarm
Bit 3 = IBS Prompt Alarm
Bit 5 = IBS Service Alarm
Bits 6 - 7 = Spares
(0 = Pass, 1 = Fail)
Bit 0 = IBS Backward Alarm or IDR Backward Alarm 1
Bit 1 = IDR Backward Alarm 2
Bit 2 = IDR Backward Alarm 3
Bit 3 = IDR Backward Alarm 4
Bits 4 - 7 = Spares
(0 = Pass, 1 = Fail)
Bit 0 = IBS/IDR Satellite Multiframe Sync Loss
Bit 1 = IBS/IDR Satellite Frame Sync Loss
Bit 2 = Spare
Bit 3 = IBS BER Alarm
Bit 4 = IBS Prompt Alarm
Bit 5 = IBS Service Alarm
Bit 6 - 7 = Spares
(0 = Pass, 1 = Fail)
0 = Front Panel, 1 = Terminal, 2 = Computer RLLP
Bit 0 = IBS Satellite Multiframe Loss
Bit 1 = IBS Satellite Frame Loss
Bit 2 = Spare
TM075 – Rev. 1.3