Table of Contents
Advertisement
DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
Turn the unit 'ON' by placing the Rear Panel Switch (located above the power entry connector) to
the 'ON' Position. Upon initial and subsequent power-ups, the DMD2401 LB/ST Microprocessor
will test itself and several of its components before beginning its main Monitor/Control Program.
These Power-Up Diagnostics show no results if successful. If a failure is detected, the Fault LED
will illuminate.
The initial field checkout of the modem can be accomplished from the Front Panel or in the
Terminal Mode. The Terminal Mode has the advantage of providing full screen access to all of
the modem's parameters, but requires a separate terminal or computer running a terminal
program. The unit is placed into Terminal Mode by setting two options via the Front Panel. The
two options are the Term Baud and Emulation settings found under the System M&C Submenus.
Terminal Setup:
Baud Rate:
Data Bits:
Parity:
Stop Bits:
TM075 - Rev. 1.3
19.2 K (can be changed via Front Panel)
8
No Parity (Fixed)
1 Stop Bit
Installation
2-3
Advertisement
Table of Contents
