Radyne DMD2401 LB Installation And Operation Manual page 82

DMD2401 LB/ST L-Band Satellite Modem and ODU Driver
<1> IDR Force
Backward Alarm
1
<1> IDR Force
Backward Alarm
2
<1> IDR Force
Backward Alarm
3
<1> IDR Force
Backward Alarm
4
<1> Interface Type
<2> Transmit ESC
Audio #1 Volume
<2> Transmit ESC
Audio #2 Volume
<1> Drop Mode
<30> DropMap
<1> Drop Alarm
Status Mask
TM075 - Rev. 1.3
Bit 3 = IDR Backward Alarm 4
Bits 4 - 7 = Spare
(0 = Mask, 1 = Allow)
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation
If G.703 Daughter Card is Installed:
0 = G.703 Unbalanced E1
1 = G.703 Balanced E1
2 = G.703 T1, B8ZS
If Synchronous Multiprotocol Daughter Card is installed:
0 = V.35
1 = RS-422
2 = RS-232
-20 to +10, Signed Binary Value (in dB)
-20 to +10, Signed Binary Value (in dB)
0 = Disable
1 = T1-D4
2 = T1-ESF
3 = PCM-30
4 = PCM-30C
5 = PCM-31
6 = PCM-31C
7 = T1-SLC96
Mapping of Satellite Channels to dropped Terrestrial
Timeslots
Bit 0 = Terrestrial Frame Lock Fault (all modes)
Bit 1 = Terrestrial Multiframe Lock Fault (PCM-30 and
PCM-30C only)
Bit 2 = Terrestrial CRC Lock Fault (PCM-30C and PCM-31C
only)
Bit 3 = Terrestrial Yellow Alarm Received (T1 only)
Bit 4 = Terrestrial FAS Alarm Received (E1 only)
User Interfaces
4-45