Table 1-3 On/Standby Switch Actions And Results; Table 1-4 Explanation Of Power States - Sun Microsystems Fire V240 Administration Manual

Press and immediately release
Press and hold down for more than 4 seconds
The results of these actions are summarised in
TABLE 1-3
Server Power State
On (with Solaris
running)
On (with Solaris not
running)
Standby
Controlling Server Power
For information on connecting the server to a power source and powering on the
server, see the Sun Fire V210 and V240 Servers Installation Guide.
For information on controlling server power using software, see the ALOM Online
Help which is located on the Sun Fire V210 and V240 Servers Documentation CD.
The server immediately goes into Standby mode as soon as it is connected to a
power source. As long as it remains connected to the power source, the server stays
in either the Standby or On power state. An explanation of the power states is given
in
TABLE 1-4
TABLE 1-4
Power State
On
Standby
Off
Note – The only way to remove power totally from the server is to disconnect the
power cable.
8 Sun Fire V210 and V240 Servers Administration Guide • April 2003
On/Standby Switch Actions and Results
Press and release
Software performs orderly
shutdown. Server enters
Standby state
No effect
Server enters On power state
.
Explanation of Power States
Description
Server is connected to a power source and the power is enabled.
Server is connected to a power source but power is not enabled.
Server is not connected to a power source. Power cable is
disconnected.
.
TABLE 1-3
Press down for more than 4 seconds
Server enters Standby state
directly
Server enters Standby state
directly
Server enters On power state