To Run Openboot Commands - Sun Microsystems Fire V240 Administration Manual

show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree.
/pci@1d,700000
/pci@1c,600000
/pci@1e,600000
/pci@1f,700000
/memory-controller@1,0
/SUNW,UltraSPARC-IIIi@1,0
/memory-controller@0,0
/SUNW,UltraSPARC-IIIi@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages@0,320//packages/terminal-emulator
/packages/disk-label
/packages/deblocker
/packages/SUNW,builtin-drivers ...
CODE EXAMPLE 6-5

To Run OpenBoot Commands

1. Halt the system to reach the ok prompt.
How you do this depends on the system's condition. If possible, you should warn
users before you shut the system down.
2. Type the appropriate command at the console prompt.
66 Sun Fire V210 and V240 Servers Administration Guide • April 2003
CODE EXAMPLE 6-5
show-devs Command Output (
shows some sample output.
truncated)