Ack Character; Nak Character - Datalogic PowerScan PD9530 Product Reference Manual

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 274
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
has been set as 7 Data Bits.
$CR2AC
Select ACK Character Setting

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
has been set as 7 Data Bits.
See page 275
$CR2NA
Select NAK Character Setting
Product Reference Guide
for more information.
0x06 'ACK' Character
DEFAULT
for more information.
0x15 'NAK' Character
DEFAULT
Enter/Exit Programming Mode
Data Bits
Data Bits
33