Set String Id; Set String Header - Datalogic PowerScan PD9530 Product Reference Manual

Enter/Exit Programming Mode

Set String ID

Sets the identifier of the predefined strings.
$CPWEB
Set String ID
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Set String Header

Sets the header of the predefined strings.
$CPWED
Set String Header
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
258
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 6 digits from the Alphanumeric charac-
Appendix D, Keypad.
ters in
The ID characters must be represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this feature
is disabled. End by scanning the ENTER/EXIT bar code
again.
~
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric charac-
Appendix D, Keypad.
ters in
The digits must be the hexadecimal ASCII representation
of the desired characters. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500