Define Strings - Datalogic PowerScan PD9530 Product Reference Manual

Define Strings

Configure string 1-5.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code at the top of
the page, then the bar code for the String you want to set. Define the label string by scanning 32
digits from the Alphanumeric characters in
The digits must be the hexadecimal ASCII representation of the desired characters; if less than
the expected string of 16 characters are selected, scan the ENTER/EXIT bar code to terminate
the string.
End by scanning the ENTER/EXIT bar code again.
$CPWEP
Set String 1
$CPWEN
Set String 3
$CPWEL
Set String 5
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
Enter/Exit Programming Mode
Appendix D, Keypad.
$CPWEO
Set String 2
$CPWEM
Set String 4
~
CANCEL
257