Set Key Sequence Id; Set Key Sequence Header; Set Key Sequence Terminator - Datalogic PowerScan PD9530 Product Reference Manual

Enter/Exit Programming Mode

Set Key Sequence ID

Sets the identifier for keyboard composed strings.
$CPWEC
Set keys sequence ID

Set Key Sequence Header

Sets the header for keyboard composed strings.
$CPWE1
Set key sequence header

Set Key Sequence Terminator

Sets the terminator for keyboard composed strings.
$CPWE2
Set key sequence terminator
270
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 6 digits from
The ID characters must be represented by their hexadeci-
mal ASCII code; if the first 2 digits are 0, this feature is dis-
abled. End by scanning the ENTER/EXIT bar code again.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric char-
Appendix D,
acters in
the hexadecimal ASCII representation of the desired
characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar code again.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric char-
Appendix D,
acters in
the hexadecimal ASCII representation of the desired
characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar code again.
PowerScan™ PD9530/PBT9500/PM9500
Appendix D, Keypad.
Keypad. The digits must be
Keypad. The digits must be