Enter/Exit Programming Mode
Configure Actions for Shift (16-key models only)
$CPWEQ0000\r
DEFAULT
Shift No Actions Configured
To configure this feature, scan the ENTER/EXIT PRO-
$CPWEQ
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to program. Next scan 4 dig-
Appendix D,
its from the Alphanumeric characters in
Keypad.
Configure Actions for Shift
The first digit must be 0; the following 3 digits must be
configured according to the CMD_ID numbers in
Table 27 on page
253. End by scanning the
ENTER/EXIT bar code again.
256
PowerScan™ PD9530/PBT9500/PM9500