Table of Contents
Advertisement
Configuring Network Event Settings
To configure network event settings
1.
2.
3.
4.
5.
Go to Main Menu > Setting > Event > Abnormality > Network.
On the Network tab, in the Event Type box, select the event type that you want to
configure settings for: Net Disconnection, IP Conflicted, MAC Conflicted.
Select the Enable check box to enable network error detection.
Select the actions that you want the system to initiate when the selected event occurs:
• Alarm Out
Select the check box to activate the selected alarm output(s) (1, 2, or 3).
In the Latch box, specify the amount of time (1–300 s) to delay the alarm
output signal after the network event is triggered.
• Show Message
Select the check box to enable a pop-up message on your local host PC.
• Send Email
Select the check box to enable the system to send an email notification.
• Record Channel Select the channel(s) that you want to record. In the Delay box, specify
the amount of time (1–300 s) to delay recording after the network event
is triggered.
• Buzzer
Select the check box to activate a buzzer noise at the DVR.
Click Apply to save your settings.
Configuring Event Settings | 91
800-19403 - A - 12/2014
Hide quick links:
Advertisement
Table of Contents
