Configuring Video Masking (Tampering) Settings - Honeywell HRHM1041 User Manual

Configuring Video Masking (Tampering) Settings

To configure video tampering settings
1.
2.
3.
4.
5.
6.
7.
8.
Go to Main Menu > Setting > Event > Detect > Video Masking.
On the Video Masking tab, in the Channel box, select the channel (camera) that you want
to configure video tampering detection settings for.
Select the Enable check box to enable video tampering detection for the selected
channel.
In the Sensitivity box, set the sensitivity level. Select a value between 1 and 6, with 6
being the highest sensitivity. The default setting is 3.
To set the periods when video tampering detection is active, next to Period, click Set, and
then follow the steps listed in
To set the actions that you want the system to initiate when a video tampering event
occurs, follow the steps listed in
Click Apply to save your settings.
To copy the settings to additional channels, click Copy, select the channels that you want
to copy the settings to, and then click OK.
To set up motion detection periods
To set up motion detection event actions
Configuring Event Settings | 89
on page 85.
on page 87.
800-19403 - A - 12/2014