Table of Contents
Advertisement
To set up motion detection event actions
1.
Go to Main Menu > Setting > Event > Detect > Motion Detect.
2.
On the Motion Detect tab, select the actions that you want the system to initiate when a
motion detection event occurs:
• Alarm Out
Select the alarm output(s) (1, 2, or 3) that you want to activate. In the
Latch box, specify the amount of time (1–300 s) to delay the alarm
output signal after a motion detection event is triggered.
• Show Message
Select the check box to enable a pop-up message on your local host PC.
• Alarm Upload
Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).
• Send Email
Select the check box to enable the system to send an email notification.
If the Snapshot function is enabled, an image can be attached to the
email.
• Record Channel Select the channel(s) that you want to record. In the Delay box, specify
the amount of time (1–300 s) to delay recording after a motion detection
event is triggered.
Note
• PTZ Activation
Select the check box to activate PTZ functions, and then click Select. In
the PTZ Activation window, for each PTZ camera, select the preset,
tour, or pattern that you want to be called when a motion detection event
occurs, and then click OK.
• Tour
Select the check box to enable a tour of the selected channels.
• Snapshot
Select the check box to take a snaphot of selected channels.
• Buzzer
Select the check box to activate a buzzer noise at the DVR.
You also need to set the motion detection recording period.
Go to Storage > Schedule to configure the current channel
for scheduled recording. See
Recording Schedule
on page 48.
Configuring Event Settings | 87
Configuring the Video
800-19403 - A - 12/2014
Hide quick links:
Advertisement
Table of Contents
