Table of Contents
Advertisement
To configure the network settings without the ATM/POS protocol
1.
Go to Main Menu > Setting > System > Card Overlay > Net.
2.
On the Net tab, configure the following settings:
• Protocol
• Overlay Channel
• Overlay Mode
• Overlay Position
• Source IP/Port
• Destination/Port
3.
Click Apply, and then click Save to save the settings.
Select POS.
Select a camera.
The Preview and Encode overlay modes are enabled by default.
Clear the check boxes if you want to disable them.
Select Top Left, Bottom Left, Top Right, or Bottom Right.
Enter the source IP and port. The source IP refers to the host IP
address that sends out the information.
Enter the destination IP and port. The destination IP refers to the IP
address of the device that receives the information.
Configuring System Settings | 117
800-19403 - A - 12/2014
Hide quick links:
Advertisement
Table of Contents
