Christie CP2230 Setup Manual page 28

Installation and Setup
6. Install the anode yoke assembly. Use this table to determine the correct position of the anode yoke
assembly:
Table 2.2 Lamp Types Available for CP2230 and Anode Yoke Position
LAMP
2.0 kW and 3.0kW
4.5 and 6.0kW
7. Install the lamp.
2-14
TYPE
CDXL-20 Move the lamp cradle to the rear position, which is approximately
1" closer to the reflector.
CDXL-30
*NOTE: A lamp adapter kit must be used with the CXL-20 lamp.
CXL-20*
CXL-30
CDXL-45 Move the lamp cradle as far forward as possible (position closest
to igniter)
CDXL-60
CDXL-60SD
ANODE YOKE POSITION
Figure 2-14 Anode Clamp Location
CP2230 Setup Guide
020-100515-04 Rev. 1 (05-2014)