Christie CP2230 Setup Manual page 30

Installation and Setup
2. Connect Lamp Leads:
DANGER
the Lamp Power Supply (LPS) and the CP2230 cinema projector are correctly connected.
a. Open the LVPS access door and use a 3 mm driver to remove the four M4 hex head screws from the
safety cage front panel. Lift the front panel over the igniter.
b. Loosen the 6 screws to remove the LPS side panel.
c. Route the cables through the strain reliefs in the LPS cover.
d. Connect the positive (+) and negative (-) lamp leads to the terminals on the LPS. using a torque setting
of 14ft/lbs (20N/m). DANGER! In order to prevent a fire hazard ensure the DC leads are
connected with the correct polarity and fastened to the torque setting specified.
e. Tighten the strain reliefs.
f. Route the positive and negative leads from the LPS through the two strain reliefs in the cinema projec-
tor baseplate.
g. Connect the negative (-) black lamp lead to the negative (-) igniter terminal, left terminal. Connect the
positive (+) red lamp lead to the positive (+) igniter terminal, right terminal. CAUTION! When
tightening the positive and negative leads, DO NOT tighten to the point that the
brackets start to bend.
h. Tighten the strain reliefs.
i. Replace the igniter safety cage.
3. Move the AC Input Line Voltage switch in the upper-left corner of the LPS to the left if you are using a 200
VAC supply, or right if you are using a 400 VAC supply.
4. Use an AC Input Terminal Block that is correct for your region to connect the AC directly to the LPS.
CAUTION!
provided to ensure adequate environmental sealing and to prevent the cable from
accidentally being torn out.
• For North America, Japan and most of Central/South America (
Wire Phase 1, 2, 3 and Ground
• For Europe (380-415 VAC):
Wire Phase 1, 2, 3, Neutral and Ground
5. Connect one end of the LPS power cord into the socket on the LPS labeled CP2230/4230 cinema
projector ONLY. Connect the other end of the power cord into the socket on the front of the cinema
projector.
WARNING!
unit, you must terminate the power connector terminal block correctly to ensure 200VAC-240VAC output.
2-16
Fire Hazard! To avoid a fire hazard ensure the high current DC leads between
Use an appropriately sized strain relief connector with the knockout plate
If you use the power connectors to power the CP2230 cinema projector or the extraction
190-208 VAC):
CP2230 Setup Guide
020-100515-04 Rev. 1 (05-2014)