Ac / Power Precautions; Lamp Precautions - Christie CP2230 Setup Manual

Introduction
government guidelines for your area. 2) Be aware that some medications are known to
increase sensitivity to UV radiation.
This cinema projector must be operated in an environment that meets the operating range specifications.
1.3

AC / Power Precautions

Installation of this cinema projector requires that an electrician hard-wire (permanent-wire) a single-phase feed
from the cinema projector to the AC supply at the building site. Operate the cinema projector at the specified
voltage.
WARNING
Disconnect cinema projector from AC before opening any enclosure.
• DO NOT allow anything to rest on the power cord. Locate the cinema projector where the
cord cannot be abused by persons walking on it or objects rolling over it. Never operate the
cinema projector if the power cable appears damaged in any way.
• DO NOT overload power outlets and extension cords as this can result in fire or shock haz-
ards.
• Note that only qualified service technicians are permitted to open any enclosure on the
product and only if the AC has been fully disconnected from the product.
Power Cords and Attachments
WARNING
Ensure that you are using a line cord, socket and power plug that meets the appropriate local
rating standards. 2) Use only an AC power cord recommended by Christie. DO NOT attempt
operation if the AC supply and cord are not within the specified voltage and power range.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in the risk of
fire, shock or personal injury.
1.4

Lamp Precautions

Lamps used in the cinema projector are under high pressure and you must handle them with caution. Lamps
can explode and cause serious personal injury if they are dropped or mishandled.
DANGER
the lamp door is open!
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield, protective
gloves, and a quilted ballistic nylon jacket or a welder's jacket. This equipment is included in included in the
Christie Protective Clothing Safety Kit #598900-095.
DANGER
clothing whenever the lamp door is open or while handling the lamp. 2) Ensure those within
the vicinity of the cinema projector are also equipped with protective clothing. 3) Never
attempt to access the lamp while the lamp is on. Wait a minimum of 10 minutes after the lamp
1-2
1) The North American rated line cord is provided with each cinema projector.
EXPLOSION HAZARD! Wear authorized protective safety clothing whenever
Lamp may explode causing bodily harm or death. 1) Always wear protective
CP2230 Setup Guide
020-100515-04 Rev. 1 (05-2014)