Table of Contents
Advertisement
PS 100
Pressure bolt adjustment
Figure 13: Relieving the sealing roller pressure
1.
Using the 8mm allen key provided, turn the four adjustment screws
anticlockwise to relieve the sealing roller pressure. (The allen key is situated on
the lip above the in-feed tray, beneath the lid.)
2.
Install the top cover, reconnect the power and switch the machine on.
3.
Press the run switch momentarily to clear any mishandled forms.
4.
When you are sure that all mishandled forms have been cleared, unplug the
mains lead from the wall outlet.
5.
Remove the top cover and tighten each adjustment screw down until you feel a
significant increase in resistance. This is a predetermined stop.
Do not overtighten the adjustment screws! Stop tightening
the screws as soon you feel a significant increase in
resistance.
6.
Install the top cover and power up the machine.
14-11-02 Iss. 1.
5. Operation Errors
Page 31
Advertisement
Table of Contents
