Pressure Seal Group PS 100 Operator's Manual page 24

PS 100
2. For each folding plate, adjust the document stop to the settings you determined
in step 1. With the folding plates removed:
•
Loosen the locking knobs at each end of the document stop.
•
Using the knobs as handles, slide the stop along the rods until the stop
aligns with the correct settings on the scales. Make sure both scales are
showing the same settings otherwise the document will not fold squarely.
•
Tighten the two locking knobs.
Figure 8: Document stop setting components
14-11-02 Iss. 1.
3. Set-up
Page 17