Table of Contents
Advertisement
4. Operation
Loading documents
When you load documents make sure:
•
There are no mishandled documents in the folder or sealer (the stop switch is not
flashing)
•
All rubber and metal rollers are clean and free of foreign matter
1.
Fan the stack of documents to make sure that they aren't sticking together.
2.
Align the stack so the documents feed correctly into the PS100. Document
orientation depends upon document design, the type of fold desired, presence
of curl, and how the folding plates are set up.
3.
Align the stack of documents so that the ends and sides of the stack are
smooth and square.
4.
Raise the feed table and feed the stack between the document guides and into
the PS100 until the stack meets resistance.
5.
Lower the feed table.
The run switch lights, indicating the stack is properly loaded on the feed table.
Make sure that the stack of documents is flat and not bowed due to the document guides
being too tight.
Page 22
PS 100
14-11-02 Iss. 1.
Advertisement
Table of Contents
