Pressure Seal Group PS 100 Operator's Manual page 30

PS 100
Starting up and testing the PS100
This procedure describes how to start up and test the PS100 to make sure
it's ready to fold and seal your documents. Always perform this procedure at
the start of each document processing session to ensure the best results.
Before you start up and test the PS100, make sure all of the following
conditions are satisfied:
•
The top cover is firmly seated on the top of the unit.
•
The folding plates are adjusted and installed properly for the fold you
want.
•
The document guides are set correctly to provide enough, but not too
much, clearance at the sides of the document stack.
•
The power switch is illuminated.
•
Documents are properly loaded and the run switch is lit.
14-11-02 Iss. 1.
4. Operation
Page 23