Direct High-Speed Connection - EverFocus EMX32 User Manual

2.4.2

Direct High-Speed Connection

In a Direct High-Speed Connection, the IP decoder connects directly to a modem without
the need for a router. You need to set the static or dynamic WAN IP address assigned by
your ISP (Internet Service Provider) in the IP decoder's configuration web pages. To access
the IP decoder, just type "http://xxx", where xxx is the IP address given by your ISP. If you
have a dynamic IP address, this connection may require that you use DDNS for a reliable
connection.
Connection Procedure:
The first step is to purchase or make a straight through cable. We recommend

purchasing one if you have never made a straight through cable. Please remember
you can not use a cross-over network cable for this application
Once you have a straight through cable plug one end into the LAN port on the back of

the recorder and the other into the high speed modem.
Log into the EverFocus IP decoder menu and go to the Network Setting Menu.

Input the Static IP address, the Subnet Mask, and the Gateway that you obtained

from the internet service provider.
Note: If you have a dynamic IP address, you can set the IP decoder to DHCP to
automatically detect the network settings. Therefore, it can use a dynamic IP address.
Exit from the IP decoder's Menu to save the settings.

To access the IP decoder from a computer, open Internet Explorer and in the address

bar type: http:// (IP address given by your internet service provider)
Note: When using this type of connection, only one device can be connected to the
modem at a time. You will need to use a computer at a different location to test the
connection s.
17
EMX32