EverFocus EMX32 User Manual page 23

Connection Procedure:
The First step is to purchase or make a straight through cable. We recommend

purchasing one if you have never made a straight through cable. Please remember
you can not use a cross-over network cable for this application.
Once you have a straight through cable, plug one end into the LAN port on the back

of the recorder and the other into the router.
Log into the EverFocus IP decoder menu and go to the Network Setting Menu.

To let the router automatically assign an address:

Set the Network Type to DHCP. Make sure to write down the IP address and the

Gateway.
Exit from the Menu to save settings.

To manually assign an address:
Go to a computer connected on the same network as the IP decoder.

Click on the Start button and choose Run.

If using Windows Vista, choose Search instead.
Type "command" and click on OK.

In Vista, you will need to double-click on the "Command Prompt" file to open it.
In the DOS prompt, type "ipconfig" and press Enter.

The network information will be displayed on a screen similar to the one below.

In Windows Vista, look for the information that says "IP v4".
15
EMX32