Port; Turning On / Off The Power - EverFocus EMX32 User Manual

Everfocus emx32 16-channel ip decoder

Hide thumbs Also See for EMX32:

Table of Contents

EMX32

2.2.4 RS-485 Port

The RS-485 port, located on the rear panel of the IP decoder, can be used to connect to an

RS-485 keyboard, such as EverFocus' EKB500, for controlling IP decoder and HD PTZ cameras.

For details on the RS-485 configurations on the IP decoder, please refer to 5.5.4 I/O Control.

The RS-485 pin assignment is as follows:

Before powering on the IP decoder, please make sure the internal HDDs have been installed

properly. When you have completed the basic cable connections, you are ready to turn on the

IP decoder.

To turn on the power, connect the supplied Power Cord to the power outlet and turn on the Power

Switch. All of the LED indicators on the front panel will light up for a second, but the Power LED

will remain light up. To turn off the power, simply unplug the Power Cord from the power outlet.

You can also press the Power Switch on the rear panel to turn on and off the IP decoder without

unplugging the Power Cord.

Table of Contents