System Setting; Date/Time - EverFocus EMX32 User Manual

5.5 System Setting

You can configure the general settings for the IP decoder in this menu.

5.5.1 Date/Time

You can set up the date and time for the IP decoder.
Date: Click to bring up the on-screen keyboard to set up the date.
Time: Click to bring up the on-screen clock to set up the time.
Date Format: Select a date format from the drop-down list.
Time Format: Select a time format from the drop-down list.
Time Zone: Select a time zone for the NVR to adjust to when updating from the time
server.
NTP: Select Disable / Enable for NTP time synchronization.
NTP Server: Displays the time server address that the NVR uses for time synchronization.
Requires operating network configuration and WAN or LAN access to a compatible NTP
server. The default NTP address is the NTP server in Taiwan. To find a compatible NTP
address of the NVR's physical location, follow the steps below:
a. Use a computer connected to the Network.
b. Click Start > Run > type "command" and then click OK.
c. In the DOS Prompt, type "ping pool.ntp.org" to find out the IP address of an NTP
Server.
60
EMX32