EverFocus EMX32 User Manual page 24

Take the values for Subnet Mask and Default Gateway and input them into the IP

decoder; these values should be exactly the same in both devices. However, you
should change the last number of the IP address. For example, if the IP address
of the computer is 192.168.2.101, the IP decoder's IP address should be
192.168.2.50.
To access the IP decoder from a computer simply open Internet Explorer and in the

address bar type:
http:// (IP address of the IP decoder)
Note: The IP decoder's IP address will only work at the location of the IP decoder. To
connect from a different location over the Internet, see below.
To set the IP decoder for Internet Connection through router:
The next step is to open ports within your router. Log into the router using a PC and

open the following ports.
Ports to open: 80

If your Internet service provider blocks port 80, you can change it to a different

port in the IP decoder's Network Menu Setup; open/forward that port instead.
If you are using a Linksys or D-Link router, see Appendix B for basic support on

setting up ports. For any other router, you will need to contact the manufacturer
for support.
To access the IP decoder from a computer simply open Internet Explorer and in the

address bar type:
http:// (the IP address given by your internet service provider)
Note: If you changed to a different port other than 80, you will need to include this
at the end of the IP address:
http:// (the IP address given by your internet service provider):port number
If you have a WAN Dynamic IP address and have opened the ports, go to 6.7.3 DDNS

Setup to configure the DDNS settings.
16
EMX32