EverFocus EMX32 User Manual page 75

EMX32
Data Bit: This field is the data bit at which you will be transferring. There are two settings
for this option: 8 or 7.
Stop Bit: This field is to set the stop bit for the RS232 connection. There are two different
stop bits, 1 or 2.
Parity: This field is to select the parity level at which you will be connected. You can choose
between None, Odd, or Even parity levels.
Control: One remote control can be used to operate four IP decoders. The IP decoder to be
addressed is selected by pressing the key corresponding to its ID number on the IR Remote
control. Please refer to Appendix C: IR Remote Control.
IR Controller ID: Set up an ID for the IP decoder and allow the IR remote control to control
this IP decoder.
67