Display; Sequence - EverFocus EMX32 User Manual

4.4 Display

You can display system and camera status on the live view screen. Follow the steps below:
1. Click the Display button
front panel to display the system and camera status. Click the button to choose the
desired display mode:
2. The following icons will be displayed at the top-left side of each camera stream to show
each camera's status.
Alarm Connection loss
3. The following icons will be displayed at the bottom of the monitor to show the system
status.
Alarm
4. There are four display modes, and you can click the Display button to change the display
mode: (1) Display both the camera and system status icons. (2) Display only the camera
status icons. (3) Display only the system status icons. (4) Hide both the camera and system
status icons.

4.5 Sequence

The sequence function is used to display each channel in sequence mode. To enable this
function:
Click the Sequence button
display one channel at a time in full screen. The channels will be displayed in the sequence
and for the amount of time as configured in the System > Display Setting > M/T SEQ submenu.
The default setting is channels 1~16 with a dwell time of 3 seconds each – repeated. Please
refer to 5.3.2 M/T SEQ for detailed information.
on the OSD Root Menu or press the Display button on the
Uninstall
Connection loss No network
to enter the sequential switching mode. The IP decoder will
Main
LAN
34
EMX32
Sequence