Paper Near End Adjustment; Paper Near End Position Adjustment - SNBC BTP-R180II User Manual

above picture.
 Confirm that the paper is rolled tightly on the paper roll, otherwise, paper jam or other fault may occur.
 The paper roll should be placed straight in the paper compartment and not at an angle. The paper roll
should be able to move freely.

4.7 Paper near end adjustment

4.7.1 Paper near end position adjustment

BTP-R180II supports printing both in horizontal and vertical positions. Users can detect the remaining
paper in the horizontal and vertical position by adjusting the paper near end sensor. The default printer
setting is for horizontal printing and the paper near end sensor is at the bottom of the paper compartment.
To change the paper near end sensor position from horizontal to vertical: First, press the plastic release
Without paper guide:
Paper guide in the slot 1:
Paper guide in the slot 2:
Paper guide in the slot 3:
Paper guide in the slot 3&4:
- 10 -
BTP-R180II User's Manual
82.5± 0.5mm.
80± 0.5mm
76± 0.5mm
69.5± 0.5mm
57 ± 0.5mm