Wall Mounting - SNBC BTP-R180II User Manual

8.4 Wall Mounting

The printer can be mounted vertically on the wall according to below instructions:
1) Drill two holes (holes (OD: 6mm: 6mm, depth: 50mm: 50mm, space of two hole: 75mm) on the wall as
in below figure:
2) Insert the plastic plugs in the holes and make sure that the plugs are fully inside the holes and do not
stick out.
3) Screw the two screws in the plastic plugs and keep10mm space between the screw head and the wall
surface.
- 20 -
BTP-R180II User's Manual