Removing The Hard Disk Drive Cage - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
9. Slide in the hard disk drive cage until hearing a click sound.
10. Replace the front panel. See "Replacing the Front Panel" on page 4-6.
11. Replace the right side door. See "Replacing the Right Side Door" on page 4-5.
additional device. For additional information, refer to the
'Configuring your system' chapter.

Removing the Hard Disk Drive Cage

1. Remove the right side door. See "Removing the Right Side Door" on page 4-4.
2. Remove the front panel. See "Removing the Front Panel" on page 4-6.
3. Unconnect the cables from the hard disk drive cage.
4. Press both slide rails ends (A) on each side of the hard disk drive cage to release
it and pull the hard disk drive cage out of the frame.
5. Replace the front panel. See "Replacing the Front Panel" on page 4-6.
6. Replace the right side door. See "Replacing the Right Side Door" on page 4-5.
Figure 4 - 5 : Installing the Hard Disk Drive Cage
Note: Modify the BIOS Setup program to recognise the
Figure 4 - 6 : Removing a Hard Disk Drive Cage
4 - 8