I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
The S-ATA Cable
Your system comes equipped with two S-ATA cables.
Both connectors go either to a hard disk drive or to the motherboard.
of the cable shown in the picture.
The SCSI Cable
Depending on your configuration, your system may come with a SCSI interface cable.
The connectors are used as follows:
one connector plugs into the SCSI adapter card,
one or several connectors plug into the hard disk drives (if applicable),
one connector plugs into the tape device (if applicable),
the last connector is a terminator (mandatory).
The SCSI interface cable is Ultra/320 compliant, meaning that it can transfer data at the
maximum speed of 320MB/s. The connectors are of the 68-pin type, and can only be
fitted one way.
Figure 4 - 5 : S-ATA Cable
Note: The color of the S-ATA cable may differ from the color
4 - 28