NEC I-Select TW100 User Manual page 80

I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
5. Locate the HDD bracket latch (B).
Figure 4 - 16 : HDD Bracket Screw and Latch
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.
6. Notice the screw holes located on each side of the HDD bracket, and the
corresponding screw holes located on the hard disk drive you mean to install.
Making sure the screw holes will line up, slide the hard disk drive into one of
the available slots, connectors last.
7. Secure screws into the three side screw holes of the hard disk drive.
8. Slide the HDD bracket into its original place.
9. Secure the screw loosened in step 5.
10. Connect the data and power cables to their respective hard disk drives. See
"Preparing the Device" on page 4-33.
11. Replace the right side door. See "Replacing the Right Side Door" on page 4-5.
Note: Modify the BIOS Setup program to automatically
recognise the hard disk drive. For additional information, refer
to the BIOS Setup chapter.
Caution
4 - 16