Installing An Expansion Card - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System

Installing an Expansion Card

1. Remove the computer right side door. See "Removing the Right Side Door" on
page 4-4.
2. Locate the add-on card holder near the slot you mean to fit with an expansion
card.
3. Pull up the relevant latch and slide it out.
4. Remove the expansion slot cover from the chassis and set it aside. Save the
expansion slot cover in a safe place in case you ever need to replace it.
Figure 4 - 2 : Removing the Expansion Slot Cover
5. Remove your expansion card from its protective packaging. Do not touch the
metal "fingers" on the edge of the card.
6. Check the expansion card's documentation for any switches or jumpers that
may need to be set, and set them now.
7. Carefully, but firmly, press the expansion card into the connector.
8. Replace the computer right side door. See "Replacing the Right Side Door" on
page 4-5.
Figure 4 - 1 : Add-on Card Holders
4 - 24