Configuring Motherboard Jumpers - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Configuring Your System

Configuring MotherBoard Jumpers

Your system's motherboard has one jumper setting: Clear CMOS jumper
(CLR_CMOS).
1. Power off the system and unplug the AC power cord.
2. The jumper is placed on one pin only: remove the jumper and position it on both
pins.
3. Wait 2 seconds.
4. Reposition the jumper on one pin only.
5. Power on the system. The message 'CMOS checksum error, Defaults loaded'
displays.
6. Press DEL to enter setup.
7. Select 'Load optimized defaults'.
8. Save and exit.
Figure 3 - 1 : Clear CMOS Jumper
3 - 13