Powering Off Your System; Forcing A Power Shutdown - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Setting Up Your System
Always allow POST to complete before powering down your
system.
If you have problems powering on your system, refer to Problem Solving in Chapter 5
of this User's Guide.
After you have successfully powered on your system, insert the EXPRESSBUILDER
CD-ROM into the CD-ROM device, reboot the system and follow the screen prompts
to run EXPRESSBUILDER.

Powering Off your System

When system power is on, pressing the power on/off switch on the front panel of the
system turns the power off.
To turn the system power off:
1. Shutdown the operating system (OS).
2. If necessary, press the POWER switch on the front of the computer chassis
again to power off the system. The POWER lamp lights off.
3. Power off the peripheral devices.
control unit such as an UPS (Uninterruptible Power Supply),
refer to the UPS user's guide for proper power-off procedures.

Forcing a Power Shutdown

A forced power shutdown can be used when the power on/off switch does not power
off the system.
To perform a forced power shutdown:
Press in on the power on/off switch located on the front panel of the system for at
least 4 seconds to force the system power off.
To power on after a forced shutdown, wait 10 seconds and then power on again.
Note:
If the system power cord is connected to a power
Caution
2 - 15