Table of Contents
Advertisement
13. ADVANCED SETTINGS
The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0
INPUT/OUTPUT (NMEA, AIS, RADAR)
13.0.0 Input
The CP390i has 4 Inputs and 5 Outputs connections. The CPF390i has 3 Inputs and 3
Outputs connections.
These ports may be set up to receive and output the following.
· NMEA-0183 - NMEA devices* set to 4800 Baud (default setting)
· Fish Finder: Only for CP390i: FF525 50/200kHz BLACK BOX FISH FINDER - refer to
Fish Finder Owner's Manual
· C-Com - C-Weather refer to Section 15
· Radar - SI-TEX optional Radar refer to Radar Owner's Manual
· AIS38400 - AIS Receiver, refer to Section 14
· MOBILARM - Mobil-arm receiver, refer to Section 16
· Disabled - allow the port to be disabled.
RS232 not opto-isolated electrical interface
When a Port is configured, both the Input and Output have the same setting.
Port1 is set to Radar, both the Input and Output wires are set to SI-TEX proprietary Radar
sentences. This means other devices should not be connected to the Input or Output wires.
13.0.1 Ouput
The ports may be setup to output NMEA sentences. The table below shows the default
setting each port.
CP390i
Sentence
GLL
VTG
BWC
WCV
APA
CP390i and CPF390i
Port1
Port2
On
On
Off
Off
Off
Off
Off
Off
Off
Off
NOTE*
NOTE
Port3
On
Off
Off
Off
On
Port4
Port5
On
On
Off
Off
Off
Off
Off
Off
Off
Off
Page 111
Advertisement
Table of Contents
