Table of Contents
Advertisement
Marine Settings, Depth Settings, Land Settings, Chart Settings or Underwater Settings
and press [ENT]. See the above sections for details on selections.
12.2
NAVIGATION PAGE
This page is useful to show information when heading to a destination, following a compassa
heading or navigating to a Mark or a Route. The default page is shown with a Compass
Rose, however this can be customized to show a Compass Tape.
1. To change to show the Compass Tape, select the Chart page, press [MENU]. Move the
ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight WINDOW SETUP and press [ENT] and press
[ENT] or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight NAVIGATION PAGE and press [ENT] and
press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint up or down to select COMPASS TAPE and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
1
Fix position
2
Time
3 Speed Over Ground
4
Course Over Ground
5
Bearing to Destination
6
Time To Go
7
Distance to Destination
8
Compass Rose
1
Fix position
2
Compass Tape
3
Time
4
Time To Go
5
Speed Over Ground
6
Distance to Destination
7
Course Over Ground
8
Bearing to Destination
The Compass Rose/Tape gives priority to the compass (Flux Gate or Gyro Compass) data if
Page 94
1
2
3
4
5
6
7
Figure 12.2 - Navigation page with Compass Rose
1
2
3
4
Figure 12.2a - Navigation page with Compass Tape
NOTE
WAAS
3D
WAAS
3D
CPF180i and CPF300i
R
8
5
6
7
8
Advertisement
Table of Contents
