Enabling And Disabling Snmp Ifindex Persistence Globally; Enabling And Disabling Snmp Ifindex Persistence On Specific Interfaces - Cisco 6500 Series Software Configuration Manual

Configuring SNMP IfIndex Persistence
To verify that ifIndex commands have been configured, use the more system:running-config command.
Note

Enabling and Disabling SNMP IfIndex Persistence Globally

SNMP ifIndex persistence is disabled by default. To globally enableSNMP ifIndex persistence, perform
this task:
Command
Router(config)# snmp-server ifindex persist
To globally disable SNMP ifIndex persistence after enabling it, perform this task:
Command
Router(config)# no snmp-server ifindex persist

Enabling and Disabling SNMP IfIndex Persistence on Specific Interfaces

To enable SNMP ifIndex persistence only on a specific interface, perform this task:
Command
Step 1
Router(config)# interface {vlan vlan_ID} |
1
{type slot/port} | {port-channel
port_channel_number}
Step 2
Router(config-if)# snmp ifindex persist
Router(config-if)# no snmp ifindex persist
Step 3
Router(config-if)# exit
1. type = any supported interface type.
Note The no snmp ifindex persistence interface command cannot be used on subinterfaces. A command
applied to an interface is automatically applied to all the subinterfaces associated with that interface.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
36-2
Chapter 36
Purpose
Globally enables SNMP ifIndex persistence.
Purpose
Globally disables SNMP ifIndex persistence.
Purpose
Selects an interface to configure.
Enables SNMP ifIndex persistence on the specified
interface.
Disables SNMP ifIndex persistence on the specified
interface.
Exits interface configuration mode.
Configuring SNMP IfIndex Persistence
78-14099-04