Cisco 6500 Series Software Configuration Manual page 447

Chapter 31 Configuring PFC QoS
Command
Step 3
Router(config-if)# wrr-queue random-detect
max-threshold queue_id thr1% [thr2%]
Router(config-if)# no wrr-queue random-detect
max-threshold [queue_id]
Step 4
Router(config-if)# end
Step 5
Router# show queueing interface type
1. type = fastethernet, gigabitethernet, or tengigabitethernet
Configuring a WRED-Drop and Tail-Drop Transmit Queue
1p3q1t ports have both WRED-drop and tail-drop thresholds in their transmit queues.
To configure the drop thresholds, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# wrr-queue threshold queue_id
thr1% [thr2% thr3% thr4% thr5% thr6% thr7% thr8%]
Router(config-if)# no wrr-queue threshold
[queue_id]
Step 3
Router(config-if)# wrr-queue random-detect
min-threshold queue_id thr1% [thr2% thr3% thr4%
thr5% thr6% thr7% thr8%]
Router(config-if)# no wrr-queue random-detect
min-threshold [queue_id]
Step 4
Router(config-if)# wrr-queue random-detect
max-threshold queue_id thr1% [thr2% thr3% thr4%
thr5% thr6% thr7% thr8%]
Router(config-if)# no wrr-queue random-detect
max-threshold [queue_id]
Step 5
Router(config-if)# wrr-queue random-detect
queue_id
Router(config-if)# no wrr-queue random-detect
[queue_id]
Step 6
Router(config-if)# end
Step 7
Router# show queueing interface type
1. type = fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to configure the low-priority transmit queue high-WRED-drop thresholds for
Gigabit Ethernet port 1/1:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface gigabitethernet 1/1
Router(config-if)# wrr-queue random-detect max-threshold 1 70 70
Router(config-if)# end
Router#
78-14099-04
Purpose
Configures the high WRED-drop thresholds.
Reverts to the default high WRED-drop thresholds.
Exits configuration mode.
1
Verifies the configuration.
slot/port
Purpose
1
Selects the interface to configure.
slot/port
Configures the tail-drop thresholds.
Reverts to the default tail-drop thresholds.
Configures the low WRED-drop thresholds.
Reverts to the default low WRED-drop thresholds.
Configures the high WRED-drop thresholds.
Reverts to the default high WRED-drop thresholds.
Enables WRED-drop thresholds .
Enables tail-drop thresholds.
Exits configuration mode.
1
Verifies the configuration.
slot/port
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
End with CNTL/Z.
Configuring PFC QoS
31-57