Cisco 6500 Series Software Configuration Manual page 467

Chapter 31 Configuring PFC QoS
Setting the PFC QoS Statistics Data Export Field Delimiter
To set the PFC QoS statistics data export field delimiter, perform this task:
Command
Step 1
Router(config)# mls qos statistics-export
delimiter delimiter_character
Router(config)# no mls qos statistics-export
delimiter
Step 2
Router(config)# end
Step 3
Router# show mls qos statistics-export info
This example shows how to set the PFC QoS statistics data export field delimiter and verify the
configuration:
Router# configure terminal
Router(config)# mls qos statistics-export delimiter ,
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : ,
Export Destination : 172.20.52.3, UDP port 514 Facility local6, Severity debug
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
78-14099-04
Purpose
Sets the PFC QoS statistics data export field delimiter.
Reverts to the default PFC QoS statistics data export field
delimiter
Exits configuration mode.
Verifies the configuration.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Configuring PFC QoS
31-77