Displaying The Supervisor Engine Redundancy; Copying Files To The Redundant Supervisor Engine - Cisco 6500 Series Software Configuration Manual

Supervisor Engine Redundant Operation
Router(config-r-mc)# end
Router# copy running-config startup-config
To manually synchronize only individual elements of the standard auto-sync configuration, disable the
Note
default automatic synchronization feature.
This example shows how to disable default automatic synchronization and only allow automatic
synchronization of the config-registers of the active supervisor engine to the redundant supervisor
engine while disallowing synchronization of the startup configuration:
Router(config)# redundancy
Router(config-r)# main-cpu
Router(config-r-mc)# no auto-sync standard
Router(config-r-mc)# auto-sync config-register
Router(config-r-mc)# end
Router# copy running-config startup-config

Displaying the Supervisor Engine Redundancy

To display both supervisor engines, perform this task:
Command
Router# show module all
This example shows how to display the supervisor engine redundancy configuration:
Router# show module all
Mod Ports Card Type
--- ----- -------------------------------------- ------------------ -----------
1
5
Mod MAC addresses
--- ---------------------------------- ------ ------------ ------------ -------
1
5
Mod Sub-Module
--- --------------------------- --------------- --------------- ------- -------
1 Policy Feature Card 2
1 Cat6k MSFC 2 daughterboard
Mod Online Diag Status
--- -------------------
1 Pass
5 Pass
Router#

Copying Files to the Redundant Supervisor Engine

Use the following command to copy a file to the slot0: device on a redundant supervisor engine:
Router# copy source_device:source_filename slaveslot0:target_filename
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
4-4
2 Catalyst 6000 supervisor 2 (Active)
48 48 port 10/100 mb RJ-45 ethernet
0001.c9db.3788 to 0001.c9db.3789
0050.f0ac.3054 to 0050.f0ac.3083
Chapter 4 Configuring EHSA Supervisor Engine Redundancy
Purpose
Displays the redundancy configuration.
Model
WS-X6K-SUP2-2GE
WS-X6248-RJ-45
Hw Fw
3.7 6.1(3)
1.0 4.2(0.24)VAI 7.5(0.6)HUB6 Ok
Model Serial
WS-F6K-PFC2 SAD06200415
WS-F6K-MSFC2 SAD06210067
Serial No.
SAD0620046D
SAD03181291
Sw Status
7.5(0.6)HUB6 Ok
Hw Status
3.2 Ok
2.3 Ok
78-14099-04